Intel SERVER SYSTEM SR2500AL - Manual (Page 94)

72 Intel® Server System SR2500AL User’s Guide
8. Lift the mid-plane board over the retention pins (see letter “B” in the figure below)
and out of the server system.
Figure 62. Removing the Mid-plane from the Server System
Installing the Mid-plane Board
1. Observe the safety and ESD precautions at the beginning of this book. See “Safety
Information” .
2. Power down the server and unplug all peripheral devices and the AC power
cable(s).
3. Remove the server system cover. For instructions, see “Removing the System
Cover” .
4. Position the mid-plane board over the retention pins as shown in the figure below
(see letter “A”).
5. Slide the mid-plane board forward (see letter “B”) and insert the mid-plane into the
backplane connector as shown.
AF000014
A
B