Sre module leds in an ex8208 switch, Figure 8: sre module leds in an ex8208 switch, Table 10: sre module leds of an ex8208 switch – Juniper Networks EX8208 User Manual
Page 52
•
Console port—Connects the SRE module to a system console through a cable with an
RJ-45 connector. See “Connecting an EX Series Switch to a Management Console” on
page 181.
•
Management port—Connects the SRE module through an Ethernet connection to a
management LAN (or any other device that plugs into an Ethernet connection) for
out-of-band management. See “Connecting an EX Series Switch to a Network for
Out-of-Band Management” on page 187.
•
Ejector levers—Used for installing and removing the SRE module.
•
Captive screws—Secure the SRE module in place.
Related Topics
Installing an SRE Module in an EX8208 Switch on page 155
•
•
Removing an SRE Module from an EX8208 Switch on page 215
•
Taking the SRE Module Offline in an EX8208 Switch on page 213
SRE Module LEDs in an EX8208 Switch
Each Switch Fabric and Routing Engine (SRE) module has four LEDs on the left side of
the module’s front panel. See Figure 8 on page 26. Table 10 on page 26 describes these
LEDs, their colors and states, and the status they indicate.
Figure 8: SRE Module LEDs in an EX8208 Switch
Table 10: SRE Module LEDs of an EX8208 Switch
State and Description
Color
LED Label (Description)
SRE module is powered on.
Green
ON (Power On)
SRE module is powered off.
Unlit
•
On steadily—SRE module is operating normally.
•
Blinking—SRE module is booting.
Green
ST (Status)
•
On steadily—SRE module has failed.
Yellow
SRE module is offline.
Unlit
Copyright © 2010, Juniper Networks, Inc.
26
Complete Hardware Guide for EX8208 Ethernet Switches