Juniper Networks EX8208 User Manual

Page 84

Advertising

Related Topics

See Rear Panel of an EX2200 Switch for port location.

•

See Rear Panel of an EX3200 Switch for port location.

•

See Rear Panel of an EX4200 Switch for port location.

•

See Front Panel of an EX4500 Switch for port location.

•

See Switch Fabric and Routing Engine (SRE) Module in an EX8208 Switch on page 24
for port location.

•

See Routing Engine (RE) Module in an EX8216 Switch for port location.

•

Booting an EX Series Switch Using a Software Package Stored on a USB Flash Drive

Console Port Connector Pinout Information for an EX Series Switch

The console port on an EX Series switch is an RS-232 serial interface that uses an RJ-45
connector to connect to a console management device. The default baud rate for the
console port is 9600 baud.

Table 29 on page 58 provides the pinout information for the RJ-45 console connector.
An RJ-45 cable and an RJ-45 to DB-9 serial port adapter are supplied with the switch.

NOTE: If your laptop or PC does not have a DB-9 male connector pin and you want to
connect your laptop or PC directly to an EX Series switch, use a combination of the
RJ-45 to DB-9 female adapter supplied with the switch and a USB to DB-9 male adapter.
You must provide the USB to DB-9 male adapter.

Table 29: EX Series Switches Console Port Connector Pinout Information

Description

Signal

Request to send

RTS Output

Data terminal ready

DTR Output

Transmit data

TxD Output

Signal ground

Signal Ground

Signal ground

Signal Ground

Receive data

RxD Input

Data carrier detect

CD Input

Clear to send

CTS Input