Juniper Networks EX8208 - Manual (Page 83)

CHAPTER 3
Component Specifications
• USB Port Specifications for an EX Series Switch on page 57
• Console Port Connector Pinout Information for an EX Series Switch on page 58
• Management Port Connector Pinout Information for an EX8200 Switch on page 59
• Optical Interface Support in EX8200 Switches on page 60
• SFP+ Direct Attach Cables for EX Series Switches on page 83
• Grounding Cable and Lug Specifications for EX8200 Switches on page 87
USB Port Specifications for an EX Series Switch
The following Juniper Networks USB flash drives have been tested and are officially
supported for the USB port on all EX Series switches:
• RE-USB-1G-S
• RE-USB-2G-S
• RE-USB-4G-S
CAUTION: Any USB memory product not listed as supported for EX Series switches
has not been tested by Juniper Networks. The use of any unsupported USB memory
product could expose your EX Series switch to unpredictable behavior. Juniper Networks
Technical Assistance Center (JTAC) can provide only limited support for issues related
to unsupported hardware. We strongly recommend that you use only supported USB
flash drives.
All USB flash drives used on EX Series switches must have the following features:
• USB 2.0 or later.
• Formatted with a FAT or MS-DOS file system.
• If the switch is running Junos OS Release 9.5 or earlier, the formatting method must
use a master boot record. Windows formatting, by default, does not use a master boot
record. See the documentation for your USB flash drive for information on how your
USB flash drive is formatted.
57 Copyright © 2010, Juniper Networks, Inc.