Switches – Juniper Networks EX8208 User Manual
Page 85
•
See Rear Panel of an EX3200 Switch for port location.
•
See Rear Panel of an EX4200 Switch for port location.
•
See Front Panel of an EX4500 Switch for port location.
•
See Switch Fabric and Routing Engine (SRE) Module in an EX8208 Switch on page 24
for port location.
•
See Routing Engine (RE) Module in an EX8216 Switch for port location.
•
Connecting an EX Series Switch to a Management Console on page 181
Management Port Connector Pinout Information for an EX8200 Switch
The management port on an EX8200 switch uses an RJ-45 connector to connect to a
management device for out-of-band management.
The port uses an autosensing RJ-45 connector to support a 10/100/1000Base-T
connection. Two LEDs on the port indicate link/activity on the port and the administrative
status of the port. See “Management Port LEDs in EX8200 Switches” on page 27.
Table 30 on page 59 provides the pinout information of the RJ-45 connector. An RJ-45
cable, with a connector attached, is supplied with the switch.
Table 30: Management Port Connector Pinout Information for EX8200 Switches
Description
Signal
Pin
Transmit/receive data pair 1
TRP1+
1
Transmit/receive data pair 1
TRP1-
2
Transmit/receive data pair 2
TRP2+
3
Transmit/receive data pair 3
TRP3+
4
Transmit/receive data pair 3
TRP3-
5
Transmit/receive data pair 2
TRP2-
6
Transmit/receive data pair 4
TRP4+
7
Transmit/receive data pair 4
TRP4-
8
Related Topics
See Switch Fabric and Routing Engine (SRE) Module in an EX8208 Switch on page 24
for port location.
•
•
See Routing Engine (RE) Module in an EX8216 Switch for port location.
•
Connecting an EX Series Switch to a Network for Out-of-Band Management on page 187
59
Copyright © 2010, Juniper Networks, Inc.
Chapter 3: Component Specifications