When the oven is first installed, Rating plate, Preparing to use your appliance – John Lewis JLDUOS705 User Manual

Page 11: When first switching on, The cooling fan for the controls, Control panel indicator neon(s), Condensation and steam, Cookware, Grill and oven furniture

Advertising
background image

11

When the oven is first installed

Remove all packaging, both inside and outside
the oven including the advertising labels and any

protective film, before using the oven.

Rating Plate

This is situated on the lower front frame of the
appliance and can be seen upon opening the door.
Alternatively the rating plate may also be found on

the back or top of some models (where applicable).
The appliance must be protected by a suitably rated
fuse or circuit breaker. The rating of the appliance

is given on the rating plate.
Do not remove the rating plate from the

appliance as this may invalidate the
guarantee.

Preparing to use your Appliance

Wipe over the base of the oven(s) with a soft cloth
and hot soapy water and wash the furniture before
use. We suggest that you run the oven elements for
10 – 15 minutes at 220°C to burn off any residue

from their surfaces. The procedure should be
repeated with the grill for approximately 5 – 10

minutes. During this period an odour may be
emitted, it is therefore advisable to open a window
for ventilation.

When first switching on

The oven has a 24 hour clock. When the oven is

first switched on at the wall the electronic display
will automatically show 12.00, and the 'Time'
indicator neon will also flash.

The Cooling Fan for the
Controls

The cooling fan comes on immediately when the grill
is switched on and after a short time when the oven

is in use. It runs on after the controls are switched
off until the appliance has cooled. During the initial
period the cooling fan may turn ON and OFF, this is

quite normal.

Always allow the cooling fan to cool the
appliance down before switching off at
the wall prior to carrying out any

cleaning or maintenance work.

Control Panel Indicator Neon(s)

The indicator neon will operate when the grill
(where applicable) or oven(s) is switched on. The
indicator neon will glow. It may turn on and off

during use to show that the setting is being
maintained.

If the neon does not operate as the instructions
indicate the controls have been incorrectly set.
Return all controls to zero and reset following the

instructions for the required setting.

Condensation and Steam

When food is heated it produces steam similar to a
boiling kettle. The vents allow some of this steam to

escape. However, always stand back from the
appliance when opening the door(s) to allow any

build up of steam or heat to release.
If the steam comes into contact with a cool surface
on the outside of the appliance, e.g. a trim, it will

condense and produce water droplets. This is quite
normal and is not caused by a fault on the appliance.

To prevent discolouration, regularly wipe away

condensation and also soilage from surfaces.

Cookware

Baking trays, dishes etc., should not be placed
directly against the grid covering the fan at the back
of the oven.

Important!
Do not use baking trays larger than 30cm x 35cm
(12” x 14”) as they will restrict the circulation of

heat and may affect performance.

Grill and Oven Furniture

The following items have been supplied with the
appliance.

1 grill pan


1 grill pan handle



1 grill pan grid



1 straight shelf (for grilling
and Top Oven cooking)


2 straight shelves (for
Main Oven cooking)

Advertising