John Lewis JLDUOS705 - Manual (Page 6)

6
Things to Note
•
This appliance is designed to be fitted between
cabinets with the recommended dimensions as
shown in Fig. 3 & 4.
•
If there is an existing housing unit it must be
removed.
•
The dimensions given provide adequate air
circulation around the unit within the cabinet,
ensuring compliance with BS EN60-335.
•
This appliance must not be installed on a
wooden base board.
•
Enquiries regarding the installation of the cooker
point, if required, should be made to your
Regional Electricity Company to ensure
compliance with their regulations.
•
The cooker point should be within 2m of the
appliance to make it accessible to switch off the
appliance in case of an emergency.
•
To protect the hands, wear gloves when lifting
the oven into its housing.
Do not lift the appliance by the handles.
Note: House Circuit
Earth leakage / continuity tests must be carried out
before the appliance is connected to the mains
supply and re-checked after fitting.
•
Make sure the space between the cabinets is the
correct size for the appliance to be fitted (Ref.
Fig. 5 & 6).
•
The plinth board spanning the space into which
the appliance is to be installed should be
removed.
•
If the size between adjacent cabinets is 605-
610mm, then the cabinets should be modified so
that the recommended dimension of at least
600-605mm is maintained.
•
The adjacent cabinets must be stable and firmly
secured to the wall or floor. If necessary, make
arrangements to ensure the work surface below
which the oven will rest is level.
•
Drill two pilot screw holes into the sides of the
adjacent cabinets, in the positions indicated by
Fig. 5.
•
Fit the appliance mounting brackets using the
two holes indicated in Fig.7 to the adjacent
cabinets (Ref. Fig.5 & 6).
•
Check that the mounting brackets are level.
They can be adjusted if necessary by using the
extra holes at the ends of the brackets. Once
the brackets are level, drill a pilot hole through
the central hole in the bracket and fit the
remaining screw.
Fig. 5
Fig. 4
Fig. 6
Fig. 7
Fig. 3