John Lewis JLDUOS705 - Manual (Page 5)

5
Installation
Technical Data
Voltage: 230-240 Volts AC 50Hz
Wattage: 5.0-5.5kW
Height: 720 mm
Width: 593 mm
Depth: 585 mm
(excluding handles and knobs)
Weight: 52kg
THIS OVEN MUST BE EARTHED
Electrical Requirements
This appliance must be installed by a qualified
electrician/competent person. Safety may be impaired if
installation is not carried out in accordance with these
instructions.
Do not remove the screws from the earth tab extending
from the oven mains terminal block (Fig. 1).
Before connecting the appliance make sure that the
voltage of your electricity supply is the same as that
indicated on the rating plate. This is situated on the
lower front frame of the appliance and can be seen upon
opening the door. Alternatively the rating plate may
also be found on the back or top of some models
(where applicable).
Do not alter the electrical circuitry of this appliance.
Electrical Connection
The cable used to connect the oven to the electrical
supply must comply to the specifications given below.
Connection
Via Min. size
Cable/flex Cable/flex
type Fuse
• Cooker
Control
Circuit
6mm 2 PVC/PVC
twin and
earth 35 A (min)
By connecting the appliance to a cooker point having a
double pole isolating switch providing at least 3mm
contact separation in all poles and protected with a fuse
or miniature circuit breaker at your mains fuse box.
If you wish to connect an oven and a hob to a cooker
point you can, by connecting the oven and hob
separately to the cooker point. See Fig. 2.
This appliance complies with:
European Council Directive
73/23/EEC.
EMC Directive 89/336/EEC.
CE Marking Directive 93/68/EEC.
Energy Label Directive 2002/40/EC.
NOTE: It is good practice to :
Fit an Earth Leakage Circuit Breaker to your
house wiring.
Wire your appliance to the latest IEE regulations.
Fig.1
Electrical Connection
Fig. 2