Lightwave Communications SCS3230 - Manual (Page 61)

A Lantronix Company SCS3230 System Administrator's Guide
15.00.038 - 61 - May 2002
sys admin>>ADDUSER
Number of available user records: 200
Number of users defined: 0
Enter user id | USER ID > tom
Enter case sensitive password | PASSWORD > ****
Re-enter case sensitive password | PASSWORD > ****
0-17 | MAX CONCURRENT LOGINS: 1> 2
Allowed devices example: 1-5,10 | DEVICES 0 > 1-4
Allowed listen devices example: 1-5,10 | DEVICES 0 > 0
Allow user to clear device buffer (Y/N) | YES > n
Clear screen after a command (Y/N) | YES > n
Enter user id | USER ID >
Sys admin>>
The above procedure has defined one user. The SCS3230 will prompt for the next user
ID to be defined. Repeat the set-up process until all users have been entered. To
return to the sys admin prompt, simply press
<ENTER> at the USER ID> prompt. More
users may be added at any time by using the ADDUSER command. A maximum of 200
users may be defined.
7.2 Editing a User ID
sys admin>>EDITUSER TOM
Enter accepts present value
Enter case sensitive password | PASSWORD >
0-17 | MAX CONCURRENT LOGINS: 2>6
Allowed devices example: 1-5,10 | DEVICES 1-4 >
Allowed listen devices example: 1-5,10 | DEVICES 0 >
Allow user to clear device buffer (Y/N) | YES > n
Clear screen after a command (Y/N) | NO > n
sys admin>>
To edit or change parameters for a particular user after defining that user ID, use the
EDITUSER command. For example, if the user 'Tom' needed to have more concurrent
login capabilities, the sys admin would type
EDITUSER TOM on the command line. As
each line comes up, change the settings and press <ENTER>, or press <ENTER> to
accept the current setting.
NOTE: When editing any group of parameters, pressing the
<ENTER> key will accept
the current value and move to the next parameter in the list.
7.3 Listing User IDs
To list the users that have been defined, use the
LISTUSERS command. When used
alone, the command will display all user ID’s. When a user ID is specified after the
command, the parameters for that user ID will be displayed. If the
/ALL qualifier is