Lightwave Communications SCS3230 - Manual (Page 80)

ConsoleServer 3200 System Lightwave Communications
Rev. A - 80 - www.lightwavecom.com
alphanumeric characters and is case-sensitive) at this prompt and press <ENTER>. After
entering the new password, the user will be asked to verify the new password by the prompt
PLEASE VERIFY PASSWORD. The user should enter the new password again at this prompt
exactly as it was typed the first time and press
<ENTER>. If both new password entries match,
the SCS3230 will display New password accepted. on the screen and return to the user
prompt. If the new entries do not match, the message New and verify password
mismatch is displayed, the new password is rejected, and the old password remains valid.
The SCS3230 will also reject a new password if the incorrect password is entered when
prompted for the old password, or if the new password is the same as the old password.
8.6 Logging Out
A user may logout at any time that commands may be made to the SCS3230 by typing
LOGOUT,
LOGOFF, or by selecting LOGOUT from a pull-down menu. When a user is connected to a server
and they logout, the connection to that server will be broken and any other users that are
listening to that session will lose their connection to that server as well.
8.7 Checking Connections
CONNECTION INFO SCREEN
+---------------------------------------------------------------------------+
¦ CONNECTION INFO ¦
+---------------------------------------------------------------------------¦
¦01 - TEST 00 - User logged-in ¦
¦02 - 00 - Channel present ¦
¦03 - 00 - Channel present ¦
¦04 - 00 - Channel present ¦
¦05 - 00 - Channel present ¦
¦06 - 00 - Channel present ¦
¦07 - 00 - Channel present ¦
¦08 - 00 - Channel present ¦
¦09 - 00 - ¦
¦10 - 00 - ¦
¦11 - 00 - ¦
¦12 - 00 - ¦
¦13 - 00 - ¦
¦14 - 00 - ¦
¦15 - 00 - ¦
¦16 - 00 - ¦
¦17 - 00 - ¦
+---------------------------------------------------------------------------+
Press Any Key To Continue ....
Only one user at a time may connect to a device on the SCS3230, except when using listen
mode (see Section 7.9, Listening to a Server Session for more details). Before attempting to
select a device port, the user may desire to check if the device port is free. The
CONNECTIONS
command allows the user to list the users that are logged in, which devices they have currently
selected, and which mode they are in. Users may also view this information by selecting
DISPLAY CONNECTED LIST from the pull-down menu when logged in.