Lopi Masonry Fireplace Factory Built (Metal) Fireplace Mobile Home Model: Pioneer Bay (Heritage Bay PI) - Manual (Page 8)

6
Installation
Travis Industries 4 0 5 1 2 1 6 9 3 5 0 8 0 5 1
Before You Begin
READ THIS ENTIRE MANUAL BEFORE YOU INSTALL AND USE THIS HEATER.
FAILURE TO FOLLOW THE INSTRUCTIONS MAY RESULT IN PROPERTY DAMAGE,
BODILY INJURY, OR EVEN DEATH.
Check with local building officials for any permits required for installation of this pellet heater and notify
your insurance company before proceeding with installation.
Packing List
• Avanti Insert • Manual • Door Latch Tool • Fuses (2) • Leveling Bolts (2) • Brush
Installation Options:
• Masonry Fireplace • Factory Built (Metal) Fireplace • Outside Air Compatible
Planning The Installation
HINT: Have an authorized Travis Industries dealer install this heater. If you install the heater
yourself, have your dealer review your installation plans.
HINT: Place the heater outside and load 10 pounds of pellets inside the hopper. Plug the
heater in and let it run on HIGH until the pellets run out. This will cure the paint and burn
off any oil on the steel, eliminating any smell inside the home.
HINT: Paint the interior of the fireplace with latex paint to prevent fireplace odors from entering
the home (the convection blower circulates air around the insert).
Minimum Fireplace Size
Min. 30"
(includes circuit board)
Min. 19-5/8"
Mantel
(combustible or non-combustible)
Non-Combustible
Facing
Min. 32"
(10" from
hopper lid)
Min. 15-1/2"
(6" from hopper lid)
Min. 34-1/8"
(6" from hopper lid)
Non-Combustible Hearth
Min. 16-5/8"
(includes 5"
for vent)
Min. 34-1/8"
(6" from hopper
lid)
Min. 35"
(13" from
hopper lid)