Polycom SpectraLink 1725-36033-001 - Manual (Page 26)

SpectraLink 8000 SVP Server: Administration Guide for SIP
26 PN: 1725-36033-001_G.doc
Navigation Option
SendAll
In an IP system with multiple SVP Servers, the SendAll option is
provided to speed configuration and to ensure identical settings. The
S=SendAll option allows you to send that configuration parameter to
every SVP Server on the LAN. SendAll can only be used after the IP
address is established on EACH SVP Server via the serial connection.
If you anticipate identical settings across the LAN, set just the IP
address and custom hostname (if desired) for each SVP Server using
the initial serial connection. Then connect via the LAN and configure
one SVP Server, pressing S to use the SendAll option to set identical
configuration options for all other SVP Servers in the system.
If
SendAll is to be utilized in your system, all SVP Server passwords
must be identical. DO NOT CHANGE THE PASSWORD AT THE
INITIAL CONFIGURATION IF THE SendAll OPTION IS DESIRED.
Use the default password and change it globally if desired after a
LAN connection is established for all SVP Servers.
If independent administration of each SVP Server is desired, the
passwords may be set at initial configuration.
The following options must be configured:
Configuration Options
All options must be given an entry, but some options do not need to
be configured. If no configuration is desired, use the default setting
NONE . If you want to clear a configuration, overtype it with NONE .
The following options must be configured:
IP Address
Enter the IP address of the SVP Server, defined by your network
administrator. Enter the complete address including digits and
periods. DHCP may be entered.
The SVP Server will automatically lock for maintenance if the IP
address is changed. When this Maintenance Lock occurs, the SVP Server
must be reset upon exit. All active calls are terminated during a reset.