Polycom SpectraLink 1725-36033-001 - Manual (Page 29)

Configuring the SpectraLink 8000 SVP Server
PN: 1725-36033-001_G.doc 29
SVP Server Configuration
The SVP-II Configuration screen is where you set the mode of the SVP
Server. It is also where you can lock the SVP Server for maintenance
and reset the SVP Server after maintenance. The type of gateway you
are using determines the mode of the SVP Server.
From the main menu, scroll to
SVP-II Configuration and select by
pressing Enter.
Ensure the SVP-II Mode is set to NetLink IP as shown in the above screen.
The following options must be configured:
Phones per Access Point
AP specifications are detailed in the Configuration Notes for each brand
and type. Refer to these notes when entering the number of
simultaneous calls supported for your type.
802.11 Rate
Select 1MB/2MB to limit the transmission rate between the wireless
telephones and APs. Select Automatic to allow the wireless telephone
to determine its rate.