Lifebreath RNC120D - Manual (Page 14)

14
Suspending the RNC120D
STRAPS
AND
SCREWS
(supplied)
JOIST
FASTENERS
(not supplied)
DETAIL
Using full length hanger
straps is recommended
for vibration control, but
can be shorter if required.
Horizontal Installation
Wall Mounting the HRV
Vertical Installation
The unit must be mounted level for proper
drainage of the condensate pans.
ATTENTION
Suspending the RNC120D
The hanging straps should be attached to the unit at the top end
corners (mounting screws are already located on the HRV case).
Securely fasten the other end of the straps to the ceiling making
sure the UNIT IS LEVEL. The straps are designed to reduce the
possibility of noise, resonance or harmonics; therefore using the
full length of the strap between the HRV and the floor joists is
recommended. "L" BRACKETS (not included) may be installed if wall
mounting is desired for the vertical installation.
It is important to isolate the "L" BRACKET from the attached
surface to minimize vibration.
Use the hanging strap hardware to attache the brackets. Do not
drill additional holes in the HRV.