TANDBERG 6000MXP - Manual (Page 35)

35 D 13887.08
MAY 2008
TANDBERG 3000 MXP & 6000 MXP
REFERENCE GUIDE FOR SYSTEM INTEGRATORS
Interfaces and Sockets – Codec 6000 MXP
Network Interface Sockets
ISDN BRI interface. ISDN I.420
(RJ-45 Jack) Basic Rate Interface
S/T (2B + D), 128 kbps per ISDN
I/F. Use any standard BRI cable
to connect the Codec to BRI.
ISDN PRI interface. 1 × PRI (RJ-45 Jack) Primary
Rate & Leased Line E1/T1 (G.703) Interface up to
2 Mbps. 1 × PRI (RJ-45 Jack) Primary Rate (for future
use). Use any standard PRI cable to connect the
Codec to PRI.
Tip! Wherever applicable, the use
of Category 5 cabling or better is
strongly recommended! For HD camera
applications, however, Category 7.5 is
required.
Ethernet LAN (RJ-45 Jack) interface (10/100 Mb).
Up to 4 or 6 Mbps, depending on the bandwidth op-
tion installed. Use any standard Ethernet cable to
connect the Codec to a LAN.
If no LAN is available and the Codec is connected
directly to a computer, use a crossover cable.
Ethernet cable
1 ---------- 1
2 ---------- 2
3 ---------- 3
6 ---------- 6
1 1
2 2
3 3
6 6
Wiring diagram
standard cable Wiring diagram
crossover cable
RJ-45 Connector pin-out
E1/T1 Interface
PRI Pin-Out Crossover
PRI cable
Pin 1 RX+ 4
Pin 2 RX– 5
Pin 4 TX+ 1
Pin 5 TX– 2
S/T Interface
BRI Pin-Out
Pin 3 TX+
Pin 4 RX+
Pin 5 RX–
Pin 6 TX–
Tip! If you connect your Codec directly to a PC, make sure you set up
the system to use static TCP/IP settings. There will be no DHCP server
controlling the little LAN created by the computer and the Codec. When
configuring a back-to-back connection between the PC and the Codec,
make sure both static IP addresses exist on the same subnet.