TANDBERG 6000MXP - Manual (Page 71)

71
TANDBERG 3000 MXP & 6000 MXP
REFERENCE GUIDE FOR SYSTEM INTEGRATORS
Configuration-type Commands – xconfiguration / configuration.xml
D 13887.08
MAY 2008
CallVideoSource: <0/1/5/6>
The Call Video Source is the default call video source you would prefer to use in a call..
Example: xconfiguration callvideosource: 0
Camera [1..13] Brightness Mode: <Manual/Auto>
Sets whether to control camera brightness of the different cameras manually or to have it automatically set by the
system.
Example: xconfiguration camera 1 brightness mode: manual
If a TANDBERG Video Switch is
connected, the camera ranges
will behave as follows:
Camera 1 will be the video •
switch.
Camera range 2..7 will
•
be cameras connected to
secondary chain (the chain
originating from Data port 2
of the switch).
Camera range 8..13 will be
•
cameras connected to the
primary chain (the chain
originating from Data port 1
of the switch).
Go to the TANDBERG Video
Switch section to read more.
Camera [1..13] Brightness Level: <0..16>
Defines the brightness level to use if Brightness Mode is set to Manual.
Example: xconfiguration camera 1 brightness level: 10
Camera [1..13] Whitebalance Mode: <Manual/Auto>
If set to Auto the camera will continuously adjust the whitebalance depending on the camera view.
When set to Manual the whitebalance can be calibrated manually by the command
CameraWhiteBalance . The white-
balance of the camera will then remain constant until a new calibration is performed.
Example: xconfiguration camera 1 whitebalance mode: auto
Camera [1..13] Whitebalance Level: <0..16>
Specifies the camera whitebalance level. Applies to TANDBERG Precision HD cameras only.
Example: xconfiguration camera 1 whitebalance level: 10
Camera [1..13] Focus Mode: <Manual/Auto>
If set to Manual autofocus will never be turned on automatically.
Example: xconfiguration camera 1 focus mode: manual
Camera [1..13] Backlight: <On/Off>
Turns backlight compensation of camera On/Off. Not applicable to TANDBERG WAVE I cameras.
Example: xconfiguration camera 1 backlight: on
Camera [1..13] DualVisca: <Off/On>
Enables or disables dual visca mode. If enabled, visca control will be available on the RJ11 connector on the camera. If disabled, the RJ11
connector will work as a normal daisy chain port. Applies to TANDBERG Precision HD cameras only.
Example: xconfiguration camera 1 dualvisca: on
Camera [1..13] Mirror: <Off/On>
Turns mirror mode on/off. Not applicable to TANDBERG WAVE I cameras.
Example: xConfiguration camera 1 mirror: on
CallVideoSource — Camera [1..13]