VIEWSONIC WPD-100 VS13789 - Manual (Page 37)

ViewSonic WPD-100 31
2-6-1 WPS Setup - PBC (Push-Button Configuration)
1. Set ‘Config Mode’ to ‘Enrollee’, and then push the ‘WPS’ button on your
wireless access point (the button used to activate WPS standby mode may
have another name), or use other way to start WPS PBC standby mode as
the instruction given by your wireless access point’s user manual.
You can also set ‘Config Mode’ to ‘Registrar’. In this mode, this wireless
network card will wait for other WPS-enabled access points to send WPS
pairing requests. Please refer to the instruction given by your wireless
access point’s user manual to understand how to send WPS requests.
2. Before you start to establish the wireless connection by using WPS, you
can click ‘Rescan’ button to search for WPS-enabled access points near
you again, to make sure the WPS function of your access point is activated.
All access points with WPS function enabled will be displayed here. Please
make sure the access point you wish to connect is displayed. If not, please
click ‘Rescan’ few more times. You can also click ‘Information’ button to see
the detailed information about selected access point.