HP XP P9500 Storage - Manual (Page 287)

8
.
Register the added LU to the application.
Adding a New LU By Restarting the Nodes (When Using Sun Cluster)
Note
Have the HDLM drivers on all nodes in the cluster recognize the LU newly
recognized by the node, and make the configuration the same for each
node.
To add a new LU:
1
.
Set up the storage system and switch so that Solaris recognizes the LU.
2
.
Check the LU newly recognized by the node and its disk label.
You can check the LU and verify that the disk label is specified by using
the format command. The following figure shows an example of the
format command. The shaded portion represents the LU newly
recognized by the node.
HDLM Operation
4-25
Hitachi Dynamic Link Manager User Guide for Solaris ®