HP XP P9500 Storage - Manual (Page 452)

Key name #1 Explanation #2
Required or
optional?
Maximum
length
(characte
rs)
Required
for new
installatio
n
Required
for
upgrade
installati
on or re-
installati
on
HDLM to assume an
intermittent error.
You can specify a value from
1 to 99. The default is 3.
dynamic_io_path_c
ontrol Specify whether to enable or
disable the dynamic I/O path
control function by using the
values below. Note that, if
this function is set, the
setting for each storage
system or LU is cleared.
on: Enabled
off: Disabled (default)
Optional Optional 3
dynamic_io_path_c
ontrol_interval
#5
For the dynamic I/O path
control function, specify the
checking interval (in minutes)
for reviewing the information
about the switching of
controllers performed by the
storage system.
#5
You can set the checking
interval from 1 to 1440. The
default is 10.
Optional Optional 4
Legend:
Optional: If you omit the key name and value, the following value is
used:
¢
For a new installation
The default is used.
¢
For an upgrade installation or re-installation
The previous setting value is inherited.
Note
Audit log settings are not supported.
#1
Only one key name and value can be specified on each line.
#2
Specifying an invalid value causes an error.
7-38
Utility Reference
Hitachi Dynamic Link Manager User Guide for Solaris ®