Australian Monitor Zone Mix 3 - Manual (Page 14)

zone or individual sends on a mono zone.
For Stereo the RC1 should be wired between pin 5 and pins 7 and 8 shorted together.
If each output is being used as an individual sub zone send then one RC1 can be wired
between pin 5 and pin7 (for Right sub zone send) and another RC1between pin 5 and pin 8
(for Left sub zone send). The zone should be set to MONO, see Internal Adjustments on page
10.
See Paging Station on page 16 for more inforamtion.
Connect cable from ZM3M to PAGE MIC connector on the ZM3.
There is no need to enable the rear panel remote
switch unless an ZM3R is also being used.
PAGING STATION
14
INSTALLATION SERIES
Australian Monitor