Iris Sample Processing Statspin® MP Multipurpose Centrifuge - Manual (Page 5)

1
Section
1
Unpacking and Installation
Inspect Packaging
The StatSpin MP and its accessories are delivered in one carton. If the centrifuge or accessories
have suffered any damage in transport, please inform your carrier immediately.
NOTE: Save shipping carton and components to simplify return should service be required.
Verify Contents
Product No.: SSMP (supplied with 2 rotors, RT12 and RH12)
SSMP-1 (supplied with 1 rotor, RT12)
SSMP-2 (supplied with sample of PlasmaRotors)
Each of the above packages contains:
One Universal Switching Power Supply
(StatSpin Product No. 01-3553-001, APS Product No.
AD-740U-1240)
One grounded line cord (for North American use only)
One Operator’s Manual
One Sample Pack-Varies depending on the package purchased
Install System
1. Place the StatSpin MP on a level surface suitable for laboratory instrumentation.
2. Maintain a 300mm clearance boundary around the centrifuge for ventilation and safety.
3. Position the StatSpin MP away from direct sunlight and sources of heat or cold.
(See Appendix A for specifications.).
Connect Power
Plug the power supply into a grounded outlet supplying the voltage and frequency indicated on the
power supply. When power is connected, the Power On LED will illuminate and the cover lock will
release.
WARNING - North American Installation: Only use the power supply included with the unit. Use
of other power supplies or transformers will damage the StatSpin MP electronics and void the
warranty.
WARNING - Outside of North America: Do Not Use the Line Cord Supplied. Use power cord
for at least 1.0 Amp or more with an IEC320/CEE22 female connector and male connector
suitable for the power outlet to be used.