DekTec DTC-300 StreamXpress - Manual (Page 57)

DTC-300-SP – StreamXpress
USER MANUAL
57
NOTE: The total bitrate of the component selected must be less than the channel rate for each
segment. If the selected component rate is higher than that channel rate, this display will turn red
and an error will be generated.
#7 Total:
This display represents the total number of segment used for the broadcast. It adds all segments
selected for layer A, B and C.
3.5.12.4 Message center and pre-set configuration
This section displays any error and allow user to select pre-set configuration.
Variable Type Description Details Diag
Message
Center
Display
Field
Displays is the configuration is valid and point to any error 1
TMCC
parameters
Drop
down
Load the TMCC parameters present in the 204 byte packet TS
file (If present)
2
Initial settings Drop
down
Load the original settings of the modulation 3
3.5.13 T2MI Modulation settings
If the DekTec Adaptor is licensed to support T2 modulation, the user can select the T2-MI
modulation mode.
To enable Single Frequency Network (SFN) operation, decisions on allocation and scheduling are
taken once in a T2-Gateway, the results of which are distributed in such a format that each
modulator in the network can unambiguously create an identical on-air signal. The DVB-T2
Modulator Interface (T2-MI) defines this format and allows reliable networks of transmitters (in both
MFN and SFN configurations) to be constructed.
When a T2MI file encapsulated into a MPEG-2 TS is open, the StreamXpress will use the information
contained in the T2-MI file to modulate the output signal. The user can only change the output
frequency of the RF channel.
1
3
2