DekTec DTC-300 StreamXpress - Manual (Page 63)

DTC-300-SP – StreamXpress
USER MANUAL
63
NOTE: The option to play through a standard NIC card requires a dongle license. Please contact
DekTec at [email protected] for more information.
Variable Type Description Details Diag
IP address Selection Enter the destination IP address (Unicast or Multicast) #1 1
IP address
messaging
Display Display information about the entered destination IP address #2 2
Port number Selection Enter the destination Port number #3 3
TTL Selection Enter the Time to Live (TTL) value #4 4
RTP/UPD Drop
down
Select between UDP and RTP transmission #5 5
Number of TS
packets per IP
Drop
down
Select the number of TS packets per IP packets #6 6
FEC Drop
down
If in RTP mode, select the type of FEC applied #7 7
#1 IP address:
This field allow setting the destination IP address of the TSoIP. There are 3 types of IP address:
Unicast targeting a single device on a network, Multicast targeting multiple devices on the network
and Broadcast targeting all devices on the network.
NOTE: If a network is not multicast aware, all multicast streams will be handled like broadcast.
NOTE: DekTec devices only support IPv4 addressing at this time.
Unicast address range is from 0.0.0.0 to 223.255.255.255, but not all of the addresses are unicast
(See broadcast address).
Multicast address range is from 224.0.0.0 to 239.255.255.255
Address range 240.0.0.0 to 255.255.254 are reserved and should not be used (However, they can
be used by StreamXpress).
1
7
3
4
2
5
6