Impact VC-500WLN 500Ws Monolight - Manual (Page 19)

19
Channels
This studio flash has a 16-channel radio receiver, which can be triggered using
the included transmitter. To adjust the channel settings on the remote, first
remove the battery compartment door. Set the device to your required channel
using the chart below as a guide.
Note: White represents the DIP switch button.
Note: The channel setting on the monolight and the transmitter must match
in order to wirelessly trigger the flash, adjust flash power, and turn on/off the
modeling lamp.
Groups
The Impact Digital Monolight has four groups, used to segment remote devices.
To change the group that the trigger transmits to, press the group selector
button repeatedly until the required group selection corresponds with the
correct indicator light.
Note: The group setting on the monolight and the transmitter must match in
order to wirelessly trigger the flash, adjust flash power, and turn on/off the
modeling lamp.
Testing the Monolight
Press the transmitter’s test button to test-fire the monolight.