Profoto A10 AirTTL-C Studio Light for Canon - Manual (Page 18)

A
10 Air
TTL
18
www.profoto.com
Getting started
Battery charging
For optimal performance, the battery should be fully charged prior to
usage. The battery can be charged from any charge level. For increased
life-time, do not leave the battery uncharged for a long time.
Charge the battery:
1. Push the battery release button [5] and remove the battery
from the flash. This can be done while the A10 is mounted on the
camera.
2. Connect the battery to battery charger [17]
3. Connect the battery charger to mains power.
4. Check that the charge indicator [18] is continuously orange,
indicating that charging is in progress.
5. When the charging is completed, the charge indicator [18] is green.
Note:
If the battery is deeply discharged, the charging time can be longer than specified in
section Technical data.
Battery blinking orange indicates battery error. Contact your local Profoto dealer for
support.
The charger mains cable and plug serve as the disconnect device from
mains power. When charging is done, always disconnect the charger
from the mains outlet by pulling the plug, not the cable.
The socket outlet should be in close proximity to the equipment and
should be easily accessible.