Marantz NR1510 5.2-Channel Network A/V Receiver - Manual (Page 188)

No sound is produced from subwoofer.
0
Check the subwoofer connections.
0
Turn on the subwoofer’s power.
0
Set “Speaker Config.” – “Subwoofer” on the menu to “Yes”. ( v p. 157)
0
When “Speaker Config.” - “Front” in the menu is set to “Large”, depending on the input signal and the sound mode, no sound may be output from the
subwoofer. ( v p. 156)
0
When no subwoofer audio signal (LFE) is included in the input signals, no sound may be output from the subwoofer. ( v p. 161)
0
You can make the subwoofer always output sound by setting the “Subwoofer Mode” to “LFE+Main”. ( v p. 161)
DTS sound is not output.
0
Check that the digital audio output setting on the connected device is set to “DTS”.
Dolby TrueHD, DTS-HD, Dolby Digital Plus audio is not output.
0
Make HDMI connections. ( v p. 39)
0
Check the digital audio output setting on the connected device. On some devices, “PCM” is set by default.
Dolby PL g mode or DTS Neo:6 mode cannot be selected.
0
It cannot be selected when “Speaker Config.” - “Surround” is set for “None”. ( v p. 157)
0
Dolby PL g or DTS Neo:6 cannot be selected when using headphones.
Audyssey MultEQ ® , Audyssey Dynamic EQ ® and Audyssey Dynamic Volume ® cannot be selected.
0 These cannot be selected when you have not performed Audyssey ® Setup. ( v p. 146)
0
Switch to a sound mode other than “Direct” or “Pure Direct”. ( v p. 96)
0
These cannot be selected when using the headphones.
“M-DAX” cannot be selected.
0
Check that an analog signal or PCM signal (Sample Rate = 44.1/48 kHz) is input. For playback of multichannel signals such as Dolby Digital or DTS
surround, “M-DAX” cannot be used. ( v p. 127)
0
Switch to a sound mode other than “Direct” or “Pure Direct”. ( v p. 96)
Contents Connections Playback Settings Tips Appendix
188
Front panel Display Rear panel Remote Index