FUJITSU DL3800 - Manual (Page 112)

USING SETUP MODE
User's Manual 5-24
MENU1 and
MENU2 Items
Table 5.3 MENU1 and MENU2 Items and Options (Cont.)
NOTES:
• Underlined options are the factory defaults.
• Asterisks identify items and options that differ for the IBM XL24E and
Epson ESC/P2 emulations. The notes are defined at the end of the table.
<CHR-SET> SET 1 IBM character set 1
SET 2 IBM character set 2
If a downloaded (soft) font is used,
the character set for that font
overrides the <CHR-SET> setting.
(*4)
ITALIC
Italic characters are available.
GRAPHIC Graphics characters (ruled lines) are
available.
<AGM> (*2) OFF Specifies that Alternate Graphics
Mode (AGM) is off. The base of line
spacing is 1/72 inch or 1/216 inch.
ON Specifies that Alternate Graphics
Mode (AGM) is on. The base of line
spacing is 1/60 inch or 1/180 inch.
<PRF-SKP> For continuous forms, this option
specifies whether an inch is skipped
around the perforation. If you are
not using software to specify a
bottom margin, select SKIP when
using thicker, multipart forms.
SKIP One inch is skipped around the
perforation.
NO-SKIP The perforation is not skipped.
Printing continues in the bottom
margin of the page.
Options Description
#05 Chapter 5 2000.09.20, 2:36 PM 24