FUJITSU DL3800 - Manual (Page 127)

Setup Mode
USING SETUP MODE
User's Manual 5-39
Table 5.6 CONFIG Items and Options (Cont.)
NOTE: Underlined options are the factory defaults.
<TEARPOS> Tearoff position.
VISIBLE Select this option when your
software positions forms to the
next top-of-form after printing the
last data. The printer performs
tearoff feed without adding a form
feed when data transfer has
stopped.
ALWAYS Select this option when your soft-
ware stops after printing the last
data. The printer performs tearoff
feed after adding a form feed when
data transfer has stopped.
Note: For both settings, tearoff
positioning will fail if the page
length setting does not match the
actual perforation spacing.
The following <TEAR-EN> item is printed when TEAROFF:AUTO
is specified for the <TEAROFF> item.
<TEAR-EN> Tearoff enabled time (offset time).
0 SEC The offset time is from when data
1 SEC transfer stops to when the printer
2 SEC performs automatic tearoff feed.
4 SEC If the printer receives data again
6 SEC within the offset time, the printer
does not perform automatic tearoff
feed.
CONFIG Items Options Description
#05 Chapter 5 2000.09.20, 2:37 PM 39