Mocomtech CRS-300 - Manual (Page 33)

CRS-300 1:10 Redundancy Switch Revision 16
Introduction MN/CRS300.IOM
1–11
1.4.4 Modem Interface Cards: CDM-Qx/QxL, -700, -710, -710G,
SLM-5650/5650A
The following tables indicate the TMI (Traffic Modem Interface) and RMI (Redundant Interface)
cards that should be used with each modem and data type:
CDM-Qx/QxL Modems
Data Type TMI Type RMI Type
EIA-530/-422/V.35, EIA-232 CRS-316
Note 1
CRS-305
G.703 T1/E1 Bal D&I , Unbal CRS-325
HSSI CRS-336
Note 2
Quad E1 CRS-365
CDM-700 Modem
Data Type TMI Type RMI Type
Note 3
OC3 Copper CRS-325
CRS-306
HSSI or GigE CRS-336
Notes 2, 4
G.703 (E3/T3/STS-1) UnBal 1 to 4 Ports CRS-345
CDM-710 Modem
Data Type TMI Type RMI Type
ASI CRS-325
CRS-306
HSSI or GigE CRS-336 Note 4
CDM-710G Modems
Data Type TMI Type RMI Type
G.703 Unbal CRS-325
CRS-306
HSSI or GigE CRS-336 Note 4
SLM-5650/5650A Modems
Data Type TMI Type RMI Type
Note 3
MIL-STD-188-114, EIA-530/-422 or Single-port
Ethernet Bridge Mode
CRS-316
Note 1
CRS-306 (GigE only)
CRS-307
G.703 Bal/UnBal CRS-325 CRS-306
HSSI or Single-port Ethernet Bridge Mode CRS-336 Notes 2, 4
CRS-306/307
Notes – As of April 2007:
1. Use CRS-316 instead of CRS-315. To maintain older TMIs in the field, Switch firmware
must also support the CRS-315.
2. Use CRS-336 instead of CRS-335. To maintain older TMIs in the field, Switch firmware must
also support the CRS-335.
3. Use CRS-306 instead of CRS-305. To maintain older RMIs in the field, Switch firmware
must also support the CRS-335.
4. For modems where the terrestrial data type is Ethernet, the User can use only one Ethernet
port in Single-port Ethernet Bridge Mode, on the modem rear panel (when using the optional
Ethernet interface).