Mocomtech CRS-300 - Manual (Page 45)

2–1
Chapter 2. INSTALLATION
2.1 Unpacking and Inspection
Step Procedure
1 Inspect shipping containers for damage.
2
If shipping containers are damaged, keep them until the contents of the
shipment have been carefully inspected and checked for normal operation.
3 Remove the packing list from the outside of the shipping carton.
4 Open the carton and remove the contents.
5
Check the contents against the packing list to verify completeness of the
shipment.
6
If damage is evident, contact the carrier and Comtech EF Data immediately
and submit a damage report.
7
If the unit needs to be returned to Comtech EF Data, use the original
shipping container.
IMPORTANT
Be sure to keep all shipping materials for the carrier's inspection.
2.2 Rack Mounting
The CRS-300 is constructed as a 4RU-high, rack-mounting chassis. Handles are provided to
facilitate removal and placement into a rack.
Mount the Switch in the rack using the mounting holes on the front panel. Use the front panel
screw holes only.
DO NOT
install rack slides to the side of the CRS-300 chassis – contact
Comtech EF Data if there are questions about rack supports.
Figure 2-1 provides a “cut-away” side view of a typical rack configuration for modems combined
with the CRS-300, CRS-280, and CRS-350. The CRS-280 IF Switch can be mounted on the back