Multi-Tech Systems MTS2SA-T - Manual (Page 16)

Chapter 4 – Command Line Interface (CLI)
Multi-Tech Systems, Inc. MultiConnect Serial-to-Serial Adapter User Guide (S000354A) 16
General Commands – Setup
General Setup Commands
General setup of a MultiConnect IP is port-independent (physical S0, S1 etc.). The following command
set is used to set the global configuration of MultiConnect IP.
Command Syntax dialout serial s0
Description Manual Telnet dialout (Internet-to-serial connectivity).
Invoked from the command shell.
Default Value NA
Success OK
Error 1. Too few arguments
“Usage: dialout serial <serial port>
Type ‘dialout ?’ for more information”
2. Invalid argument
Possible argument(s) are: Serial
1. When invoked from Serial Shell
This command is not supported through serial dial-in
Command Syntax Exit
Description Exits the command parser, unlocks the configurations, terminates session.
Default Value NA
Success OK
Command Syntax Help
Description Provides the first level of commands in MultiConnect IP.
Default Value NA
Success OK
Command Syntax restore default-config
Description Restores the factory defaults.
Note: All previous configurations will be lost upon invoking this command.
The changes are made permanent only if save config is invoked.
Default Value NA
Success OK
Error 1. Too few arguments
”Possible arguments are default-config and session
2. Invalid argument
Invalid argument “invalid string”
Valid arguments are default-config and session
Command Syntax restore session
Description On Telnet dialout, the control is transferred to the command parser passing
the escape sequence “+++ inet”. Invoking “restore session” would resume
the Telnet dialout exiting the command parser.
Default Value NA
Success OK
Error 1. Too few arguments
Possible arguments are default-config and session
2. ERROR: Session not opened