Mocomtech CDM-570 - Manual (Page 186)

CDM-570/570L Satellite Modem with Optional IP Module Revision 4
Front Panel Operation MN/CDM570L.IOM
6–62
6.18.7 (UTIL) FIRMWARE
This series of sub-menus permits the user to view information about the CDM-570/570L
internal firmware. The modem can store two complete firmware images, and the user can
select which image will be loaded the next time the unit re-boots.
IMPORTANT
THESE MENUS ARE FOR DIAGNOSTIC PURPOSES. ONLY CHANGE AN IMAGE IF
INSTRUCTED TO DO SO BY COMTECH EF DATA CUSTOMER SUPPORT
TECHNICIANS.
Select either Info or Select, using the
◄ ► arrow keys. Press ENTER.
If Info is selected, the following sub-menu is displayed:
Use the
◄ ► arrow keys and ENTER key to select and view information about
the Bootrom, the 2 images, or the IP module (if installed).
Each image is further broken down as follows:
Use the ◄ ► arrow keys and ENTER key to select which element is then
displayed. A screen similar to the one shown below will be displayed:
If the user selects Select, the following sub-menu is displayed:
The top line shows the current active image. On the bottom line the user may
select, using the
◄ ► arrow keys and ENTER key, the image that will be active
the next time the unit is re-booted.
Firmware Images:
Info Select (
◄ ►,ENTER)
Firmware Info: Bootrom
Image#1 Image #2 MPP50
Image#x: Bulk Main-FPGA
App Turbo-FPGA RS-FPGA
Bulk#x: 01/21/04
FWxxxx 1.1.1
Current Active Image: #1
Next Reboot Image: #1 #2