Meco 6212S00T91 - Manual (Page 13)

13
1/4-20 x .39” Bolt
4 pcs
Step 11
Bowl to Cart Assembly
Place the Bowl Supports on top of the U-Frames, aligning the
holes. Attach the Bowl to the cart with four 1/4-20 x .39” Bolts
through the bowl Supports and into inserts in the top of the
U-Frames.
5/32-30 x .31” Bolt
4 pcs
Step 12
Manifold Assembly
(and Piezo Igniter Assembly on Model 6212)
NOTE: Regulator hose is shipped attached to the Manifold.
(Model 6512 has Ignition Module pre-installed)
A. Insert valve stems out through front of the Control Panel
so that the holes in the valve brackets align with the holes in
the Control Panel. Fasten in place with four 5/32-30 x .31”
Bolts through the Control Panel into the valve brackets. The
Regulator hose will be on the LEFT side.
B. (6212 only) Install the Piezo Igniter by first, removing
the large nut shipped threaded in place on the igniter, then
inserting the igniter through the large hole nearest the right
end side of the Control Panel and then fastening in place
with the large nut previously removed.
Piezo Igniter
A
B
Large Nut