Schneider Electric 890USE17700 - Manual (Page 73)

STB NIP 2212 Web Server
890USE17700 April 2004 73
IP Parameters The IP address for the STB NIP 2212 has the four parameters, which are described
in the following table:
Using the
Command
Buttons The following table describes how to use the command buttons on the Configured IP
web page:
Parameter Description
IP address Unique 32-bit address assigned to every node on the Internet.
subnet mask The subnet mask is 32 bits assigned with the IP address of a host. The
contiguous 1’s of the mask are used to separate the network portion from the
host portion of the address. When the subnet mask is applied to the source
and destination addresses, it determines if the target host is on the local
subnet or on a remote network.
gateway The default gateway, typically a router, is where the host sends frames that
are bound for remote networks after the subnet mask compare.
frame type Data format used by a protocol. For example, the STB NIP 2212 can use
either the Ethernet II or the IEEE 802.3 frame format. Ethernet II is the default.
Note: The IP address for the STB NIP 2212 is written in dotted decimal format.
To ... Click on ...
Display the IP address stored in Flash memory Reset
Display the MAC-based, derived default IP address. Default
Save the IP address displayed on the Configured IP web page. Save
Configure the STB NIP 2212 with the IP address displayed on the
Configured IP web page. Reboot