Extron Electronics DMP 128 User Guide - Manual (Page 78)

Click a mix-point to bring focus to that mix-point. A circle appears around the teal
mix-point, which remains transparent. Double-click a mix-point to open a configuration
dialog box with the following components:
• mono Fader — Sets the signal level from the
selected input to the output bus. Gain range is -35 dB
to +25 dB. Fader behavior is identical to the input
channel gain block described in the mic/line input
section with the exception that course adjustment
(<Page Up> and <Page Down>) increases or
decreases in 5 dB increments.
• mute — Mutes and unmutes the signal to the output
bus. The mix-point ball is transparent when muted
(Mute button red) and solid when unmuted.
• No Automixing — When selected, bypasses all
automix channel inputs. The mix-point is teal.
• Includes Automixing — When selected, includes
the automix channel input. The mix-point turns
solid orange when the mix-point is unmuted and
transparent orange when muted.
• No Input Processing — When checked, bypasses
all processing for the preceding input string. This
allows a direct comparison of sound between the
unprocessed signal and fully processed. The mix-point
turns green when unmuted and transparent green
when muted. Default is cleared.
• OK/Cancel — click OK to accept changes and close
the box. Cancel ignores changes and closes the
dialog box.
The title above the fader reflects the input and output
channel names for the mix-point. The example on the right
is the Input #1 to Output #1 mix-point set to 0.0 dB.
The input level text below the mute button indicates the input level setting for the input
gain control or mute status of the selected input signal path, in this example 0 db.
Only when the mix-point is unmuted does the circle become solid.
notE: The No Input Processing and Includes Auto-mixing buttons
are mutually exclusive. You cannot select both. If you are including an automix
channel in the signal path, when you select No Input Processing, Include
Auto-mixing clears and does not turn back on even when No Input
Processing is unselected. If you want to continue to have an automixing channel
in the signal path, it must be selected again.
Mix-point
Input #1
Output #1
-35
0.0 dB
25
Mute
No Automixing
Includes Automixing
No Input Processing
Input level is set to 0 dB.
OK Cancel
DMP 128 • Software Control 72