Gilderfluke&Co 'Smart' Brick Animation Control System - Manual (Page 12)

A MiniBrain can be used if you don’t need to syn-
chronize your show with an external time code or ran-
domly access more than two shows.
Smart Brick Brains are attached to the Smart Bricks
by up to a mile of six conductor modular telephone
wire. (This is the same type of wire and connector as
found on the standard Bricks, but is incompatible with
the signals which they use.) Just about any number of
Smart Bricks can be attached to a single Brain (If the
wire runs are long and there are a lot of Smart Bricks
attached, a repeater may be required in the line.)
Make sure that this cable does not have its wires
flipped from one end to the other. If the wire run is
long, then a terminator should be installed at the two
extreme ends of the line.
The Smart Bricks are available in a variety of config-
urations to suit your needs:
• BR-MultiBrick32: Thirty-two output Program-in-Place
Brick.
• BS-CRD: thirty-two output playback-only Smart 'Brick'
card. For mounting in card cages or on standoffs.
Shows are stored in Eprom.
• BS-ANA: Analog Output Smart Brick card. Features six-
teen 0-10 volt and two hundred fifty-six channels of
DMX-512 output. Runs from DMX-512 input or onboard
show data EPROM. (Refer to the BS-ANA manual for de-
tails on this product.)
• BS-EFB: Four Channel Electronic FeedBack Smart Brick
card. Runs from DMX-512 input or EPROM.
• BS-DMX-Tx: DMX-512 output Smart Brick. Sends two hun-
dred fifty-six channels for controlling lighting equipment.
G
ILDERFLUKE
& C
O
.• 205 S
OUTH
F
LOWER
S
TREET
• B
URBANK
, C
ALIFORNIA
91502 • 818/840-9484 • 800/776-5972 •
FAX
818/840-9485
E
AST
C
OAST
/F
LORIDA
O
FFICE
• 7041 G
RAND
N
ATIONAL
D
RIVE
• S
UITE
128d • O
RLANDO
, F
L
. 32819 • 407/354-5954 •
FAX
407/354-5955
2 of 178