Gilderfluke&Co 'Smart' Brick Animation Control System - Manual (Page 126)

and then recycles. When the user selects an input
which has been configured with this option, the
Smart Brick Brain uses the current value of this coun-
ter to select and play a next show. If the randomizer
played the same show the last time, it will spin the
randomizer another time to try and select another
show to play. If after this second spin, the same
show comes up, then it will be played.
c) Normally: The inputs will behave as described as
set by the next two options. You can select whether
the input will pause, continue, stop, stop at end,
start, start looping, or trigger a tape deck output.
“c” Select from J6:
If more than one show is stored on a single Smart
Brick System, each one can be accessed individually
and played back. Up to two hundred fifty-five of these
shows can be stored on a single Smart Brick System.
These requests can be made through the serial port or
through the 1/4 J6 Port.
This toggle enables the 1/4 J6 Port for requesting the
shows on this Smart Brick System. There are two methods
of selecting shows from this port. Which one is used is se-
lected by the DIRECT SELECT command.
“d” Direct Select:
This command is used to switch the 1/4 J6 Port over to
selecting one of eight shows directly, instead of using bi-
nary inputs for requesting up to two hundred fifty-five dif-
ferent shows. The DIRECT SELECT is useful when you have
eight or less shows which need to be called up through
the 1/4 J6 Port. The 1/4 J6 Port can be wired directly to up
to eight different pushbuttons. When any of these but-
tons are pressed it will select the appropriate show. The
G
ILDERFLUKE
& C
O
.• 205 S
OUTH
F
LOWER
S
TREET
• B
URBANK
, C
ALIFORNIA
91502 • 818/840-9484 • 800/776-5972 •
FAX
818/840-9485
E
AST
C
OAST
/F
LORIDA
O
FFICE
• 7041 G
RAND
N
ATIONAL
D
RIVE
• S
UITE
128d • O
RLANDO
, F
L
. 32819 • 407/354-5954 •
FAX
407/354-5955
116 of 178