Gilderfluke&Co 'Smart' Brick Animation Control System - Manual (Page 56)

Stop at End Commands
“%” (track#) Stop at End Track:
“&” Stop at End Global:
“'” Stop at End Cocked:
“(” (group) Stop at End Group:
These commands reset the cycling mode in the se-
lected Smart Brick Brain(s) . What this dies is to stop them
playing when the end of their current shows are
reached. The STOP commands are used when you
want to stop a show immediately. These commands are
used when you want the shows to finish gracefully.
If the ‘ALLOW CHAINS’ option has been selected on a
Smart Brick Brain, then any immediate jumps to whatev-
er the next show is will take place even after the cycling
mode has been stopped by using these commands
Select Show Commands
“)” (track#) (show#) Select Show Track:
“*” (show#)
Select Show Global:
“+” (show#) Select Show Cocked:
“/” (group) Select Show:
Up to two hundred fifty-five different animated shows
can be stored on a single Smart Brick System. These
commands can be used to select an individual show
on the selected Smart Brick Brain(s). Individual shows can
be requested with SHOW# requests with a range of 01 to
3Fh (01 to FFH with a Rack Smart Brick Brain). Once a
show is selected, it will be played on the next start (the
start can come from a serial port command, a hard-
ware input command, or at the end of the normal
countdown between shows if the Smart Brick Brain is cy-
cling. When it has finished playing the requested show
(or sequence of shows), you have the option of letting
the Smart Brick Brain return to what would have been the
G
ILDERFLUKE
& C
O
.• 205 S
OUTH
F
LOWER
S
TREET
• B
URBANK
, C
ALIFORNIA
91502 • 818/840-9484 • 800/776-5972 •
FAX
818/840-9485
E
AST
C
OAST
/F
LORIDA
O
FFICE
• 7041 G
RAND
N
ATIONAL
D
RIVE
• S
UITE
128d • O
RLANDO
, F
L
. 32819 • 407/354-5954 •
FAX
407/354-5955
46 of 178