Gilderfluke&Co Sd-50 Audio & Show Controllers - Manual (Page 59)

e)
Schedule being used, or ‘none loaded’ if no schedule file has been found, or ‘none today’ if
there is a schedule being used on this day. Note that the schedule being used is only up-
dated on even minutes, as the schedule is scanned.
8)
GPS data.
a)
Latitude
b)
Longitude
c)
Elevation
d)
Speed
e)
Heading
f)
Number of satellites being received
g)
Horizontal Dissolution of Precision: This is an indication of the relative accuracy of the sig-
nal being received. The more satellites being used, the greater the accuracy of the re-
ceived signal.
9)
Information on the currently loaded SoundFiles.
a)
Name of the Show (in DOS 8.3 format).
b)
Status of the Sound playback:
i)
Stopped
ii)
Playing (at the end of the SoundFile it may or may not play another sound file).
iii)
Looping. At the end of the sound, it will loop the same SoundFile as seamlessly as
possible.
iv)
Paused. Playing or Looping, but it has been paused.
c)
Name of the SoundFile (in DOS 8.3 format).
d)
Seconds into the SoundFile.
e)
Volume of the left and right sides of the repeater output. A value of 255 is at maximum. It
displays ‘muted’ when not playing.
3) ! Card Reset: “j5AA5” [nn] (card address)
This command will erase the 'Flash' memory on the Sd-50/xx. It erases any show, Calendar and GPS
data files. Whatever is stored on the Sd/MMC flash card is unaffected.
4) ! Start Commands
! ! Start Track: “t” [nn] (card address)
! ! Start Global: “u”
These commands start the animation playing on the Sd-50/8(s) or Sd-50/40(s) addressed by the
command. The shows will always start from the beginning. If an addressed Sd-50/8 or Sd-50/40 is looping
shows, it will have the ‘LOOPING SHOWS’ flag reset.
If the Sd-50/8 or Sd-50/40 receives a start command after it has received a request for a specific show,
it will play that show. Otherwise, it will play the show that has been set as the ‘next’ show for the show
which is currently playing (or most recently played show if it is not currently playing). If this is the first show
Gilderfluke & Co.• 205 South Flower Street • Burbank, California 91502 • 818/840-9484 • 800/776-5972 • fax 818/840-9485
Sd-50/xx Manual / October 29, 2012 2:29 PM / page 59 of 120