Teledyne LeCroy WaveRunner 6 Zi and 12-Bit HRO Getting Started Manual - Manual (Page 149)

Getting Started Manual
922136-00 Rev A 141
B
Note : An Analysis function also comes with the VSA Software which can send
signal traces to VSA as a recording (time domain) file.
6. You can use the Auto Save feature to automatically save a waveform
to disk after each new trigger. You can enable Auto Save from the
Save Waveform dialog by touching one of the Auto Save buttons.
Select Wrap (old files overwritten) or Fill (no files overwritten).
CAUTION. Selecting Fill can quickly use up all the hard disk
space on your instrument.
7. Touch the Browse button next to the Save file in directory control
and navigate to the location where you want the file saved. The file
name is assigned automatically and is shown under the control.
8. Finally, touch the Save Now! button.
Recalling Waveforms
Note : Only .trc files saved in binary format can be recalled into the oscilloscope.
Access the Recall Waveform dialog by either selecting File → Recall
Waveform from the menu bar or clicking the Recall Waveform button on
the main Save/Recall dialog.
Use the numbered sections of this Recall Waveform dialog, which
correspond with the following explanations, to properly recall your
waveform(s).
1. Select either Memory or File by touching either respective button on
the Recall From portion of the dialog.
Note : When Memory is selected, only Source , Destination , and Show
on recall controls are shown on the Recall Waveform dialog. When File is
selected, many more controls are available. Regardless, the controls are
used as explained in the following steps.