Teledyne LeCroy WaveRunner 6 Zi and 12-Bit HRO Getting Started Manual - Manual (Page 171)

Getting Started Manual
922136-00 Rev A 163
B
Note : Print colors are used only when the Colors control is set to Print on
the Hardcopy dialog in Utilities → Utilities Setup... allowing colors to
still appear when printed on white paper in order to save ink/toner. For
convenience, the
Preview print colors button is provided on this portion
of the dialog. When the button is touched, a preview is generated on the
grid display area. A subsequent touch of the button closes the preview.
Miscellaneous
Other Preference setting controls are shown on the Miscellaneous dialog as
follows:
Numbered sections on this dialog correspond with the following
explanations.
1. You can add the Teledyne LeCroy Logo to hardcopies of your grid
display waveforms by marking the Print Teledyne LeCroy Logo
When Printing Grid Area Only checkbox on the Hardcopy section of
the dialog.
2. You can adjust the Dimming and Control Sensitivity of Zoom traces
as follows:

Use the Dimming control to choose select On, Off, and Auto
values. This controls the darkening/shading of waveform areas
not part of the Zoom trace.

Use Control Sensitivity to choose Legacy or Optimized values
3. If you have Serial Data Debug Solutions installed on your
oscilloscope, you can control Annotations being put On Trace (on all
traces) or On Noisy Trace (only on noisy traces).
4. You can shut off the SuperKnob Help flyout menu by un-marking the
SuperKnob Help checkbox on the Other section of the dialog.