Teledyne LeCroy WaveRunner 6 Zi and 12-Bit HRO Getting Started Manual - Manual (Page 40)

WaveRunner 6 Zi and 12-Bit HRO
32 922136-00 Rev A
Probe interfaces differ in bandwidth, so the interfaces contained on your
oscilloscope depend on the bandwidth rating of the oscilloscope model you
purchased.
When a probe is connected, it is recognized and an additional tab with the
probe model name is displayed to the right of the C1 tab.
The channel dialog layout showing Input A's ProLink interface controls setup
after connection.
This additional tab contains specific information on the connected probe.
In addition, default values for the probes coupling and attenuation (which
may not be changed) are automatically downloaded from the probe, and
these settings along with other attributes are shown on the corresponding
probe dialog.
The dialog showing the connected probe's control attributes.
ProBus Interface
The ProBus interface contains a 6-pin power and communication
connection and a BNC signal connection to the probe. It offers both 50 Ω/1
MΩ input impedance and provides probe power and control for a wide
range of probes such as high impedance passive probes, high impedance
active probes, current probes, high voltage probes, and differential probes.
ProBus also includes sense rings for detecting passive probes. The ProBus
interface may also have a BNC-terminated cable connected directly to it.