Watlow ANAWIN 2 - Manual (Page 107)

Using the Developer
AnaWin User’s Guide 10-13
Test Button: Click the Test button to preview the settings you have
made. Each time you click the Test button, the digital I/O test object
changes display states.
Height (Pixels): Use the Height field to enter the height (in pixels) for
the field, then press Enter.
Width (Pixels): Use the Width field to enter the width (in pixels) for the
field, then press Enter.
Top Position: Use this field to enter the top position (the number of
pixels from the top of the screen, under the toolbar) for the digital I/O
text on the custom overview screen.
Left Position: Use this field to enter the left position (the number of
pixels from the left of the screen) for the digital I/O text on the custom
overview screen.
Digital I/O Image Properties
Use the Digital I/O Image Properties table, shown in Figure 10-10, to
select graphics to indicate the state of a controller’s input or output.
FIGURE 10-10 Digital I/O Image Properties Table
You can set the following digital I/O image properties:
Controller Type: Use the Controller Type pull-down list box to select
an available controller type.
Controller Name: Use the Controller Name pull-down list box to select
an installed controller of the type selected in the Controller Type list
box.
Digital Type: Use the Digital Type pull-down list box to select whether
the reference is an Input or an Output.
I/O Name: Use the I/O name pull-down list box to select an available I/
O point of the selected Digital Type.