Hired-Hand Unitized Mega Cool: Square Bottom - Manual (Page 15)

Part No. 4801-5396 Rev. 5-08 Unitized System - Square Reservoir Page 15 of 63
Bottom Support baraket
1. Bolt the Support Bracket to the L-Bracket attached to the Square Bottom Support Brackets. (See page
10)
2.
Attach the Bottom Support Bracket to the L-Bracket using 1/4-20 x 1/2" Hex Bolts and 1/4-20 Wing
Nuts. Do not tighten at this time.
3.
Install the Support Brackets along the entire length of the system.
4.
Starting with the two Bottom Support Brackets in the center of the system, butt the ends together and
tighten wing nuts. Then butt all the other Bottom Support Brackets together, working toward the
center, and tightening the nuts.
Bottom Support
Bracket
Bottom Support
Bracket
Attached
Bottom
Support
Bracket
Wing Nut
L Bracket
(Previously attached to
Square Bottom Support
Bracket)
Side
View
14-20x1/2” Hex
Bolt