Hired-Hand Unitized Mega Cool: Square Bottom - Manual (Page 48)

Part No. 4801-5396 Rev 5-08 Unitized System – Square Reservoir Page 48 of 63
5.
Pull the back panel (panel with largest hook and loop strip) upward underneath the drive pipe and attach to
the hook and loop strips on the back plate. Align top of curtain even with top of hook and loop strip on back
plate. Stretch the curtain taut. Press curtain firmly to secure.
6. Locate the center panel and attach the hook and loop strip on the edge of this center panel to the hook and
loop strip on the drive pipe. Pass the center panel underneath the drive pipe before securing hook and loop
strips to the drive pipe.
7. The front panel of the curtain passes underneath the top bar. The hook and loop strip of the front panel
attaches to the hook and loop strip on the top edge of the top bar.
8. The curtains also have hook and loop strips running along the sides. These strips attach to the back edges of
the track units, and inside the front edges of the track units. Press these hook and loop strips firmly to secure
the curtain.
Attaching Curtain
Drive pipe
Back panel
(Hook and loop strip
located on reverse
side of curtain).
Center panel
Front panel hook and loop strip is
located at end of curtain roll.
a. Back panel hook and loop strip is
located on reverse side of curtain.
This hook and loop strip attaches to
hook and loop strip on the back plate.
Bring curtain underneath the top bar
and drive pipe to attach.
b. Hook and loop strip on center panel
attaches to the hook and loop strip on
the drive pipe. Bring the center panel
underneath and over the drive pipe to
attach. a
b