LumaSense Technologies INNOVA 1412i - Manual (Page 22)

Chapter 2
______________________________________________________________________
_____________________________________________________________________________
BE6025-15 1412i Photoacoustic Gas Monitor LumaSense Technologies A/S
Page 22 of 202
10. Here the IP address of the 1412i, which has been assigned by the
DHCP server, is displayed. This IP address can be used to
manually set Ethernet communication in a PC application, which
accesses the 1412i gas monitor.
Press the S2 (ACCEPT) key to accept.
11. This concludes the setup of the Ethernet parameters of the 1412i
gas monitor.
Press the SET-UP key to leave the setup.
2.5.2 Display the Homepage of the gas monitor
The homepage of the 1412i gas monitor can be displayed if the gas
monitor is connected to an Ethernet network.
In section 2.5.1 it is explained how to set-up the Ethernet
parameters in the 1412i gas monitor.
Any web browser can be used to display the homepage of the gas
monitor. The IP address obtained from the Ethernet set-up of the
1412i gas monitor can be entered in the address field of the web
browser in order to display the homepage.
The last measured gas values are displayed together with
information about the gas monitor, like the device serial number, if
water- and cross-compensation is performed.
Error and warning messages (see Chapter 15 for further details) will
also be displayed on the homepage.
The grey "Update Measurements" link can be used to update the
homepage with the last measurement results.
CURRENT DHCP ADDRESS 192.168.000.062
ACCEPT