LumaSense Technologies INNOVA 1412i - Manual (Page 66)

Chapter 5
______________________________________________________________________
_____________________________________________________________________________
BE6025-15 1412i Photoacoustic Gas Monitor LumaSense Technologies A/S
Page 66 of 202
· Copying data from its Source Memory into its Working
Memory. This means that set-up parameters in block 3 of
Working Memory “Other Set-up Parameters” will be given
their default values, and the values of the optical filter set-
up parameters in Working Memory will be the same as
those found in Source Memory.
5.4 Configuring the Monitor
5.4.1 Setting the Clock
Before dispatch from the factory, the internal clock of the Monitor is
set to the correct local (Danish) time.
The current date is entered as Year-Month-Day for example the
24 th of July 2014 is entered as 2014-07-24.
The current time is entered as the time on the 24-hour clock for
example 14:05 is five minutes after two in the afternoon. Table
5.2 details the range of acceptable values and the default value of
the date and time.
Table 5.2 The range of acceptable values and the default value of
the date and time
Display Text Acceptable Values Default
Value
ENTER CURRENT DATE 0000-01-01 0000-01-01 to 9999-12-31 2013-01-01
ENTER CURRENT TIME 12:47 00:00 to 23:59 12:00
If the Monitor is to be used as a stand-alone instrument, then the
clock can be adjusted to your local time using the following
instructions.
1. Press SET-UP.
Refer to the Set-Up Tree diagram, so that you can follow your
progress through the various branches of this set-up.
2. Press S3 S1 S1 S1.
The following screen picture appears:
3. To change the date, press ¿ .
CURRENT DATE 2014 – 06 – 13
PRESS ENTER TO CHANGE VALUE