LumaSense Technologies INNOVA 1412i User Manual
Page 65
Chapter 5
______________________________________________________________________
_____________________________________________________________________________
BE6025-15
1412i Photoacoustic Gas Monitor
LumaSense Technologies A/S
Page 65 of 202
5.3.4
Full reset and/or Partial Reset of the Monitor via its
Front Panel
There are two well-defined levels of reset. By pressing RESET the
following text appears on the display screen:
If S3 is pressed, you can come out of reset mode without performing
any kind of reset. The Monitor just goes back to operating the same
way it was operating before the RESET push-button was pressed.
S1 PARTIAL Reset: If this level of reset is chosen the Monitor
stops operating, performs a partial reset as described in the
previous section (
) and then resumes operating in
the fashion described in
S2 FULL Reset: If this level of reset is chosen the Monitor responds
by changing the text on the display so that you have a chance to
confirm that you wish the Monitor to perform a FULL reset:
S1 By pressing this push-button the user can come out of reset
mode without performing any kind of reset. The Monitor just
goes back to operating the same way it was operating before
RESET was pressed.
S3 By pressing this push-button the user confirms that a FULL
reset is required. During a FULL reset the Monitor performs the
following two tasks:
·
“Clearing” (emptying) all data from its Working Memory.
This means all data in Display Memory and Background
Memory will be lost.
SELECT RESET TYPE
PARTIEL FULL NONE
PERFORM FULL RESET ?
NO YES