Figure 45 display item pane, 45 display item pane – HP XP Continuous Access Software User Manual
Page 74
74
Continuous Access XP for the XP1024/XP128
3.
Right-click the graph area, and click Display Item. The Display Item pane appears.
Figure 45
Display Item pane
4.
To display I/O statistics for all LDEVs in the subsystem, click Subsystem Total. To display I/O statistics
for a specific LU, click LU, and enter the LU by selecting the port from the drop-down list and entering
the group (00-7F) and LUN (00-FF).
NOTE:
CU:LDEV is displayed on the top of the graph. If # is added to the end of the LDEV
number, such as 00:3C#, the LDEV is an external volume. For details about external volumes, see
the HP StorageWorks External Storage XP user guide.
5.
In the Monitor Data area, select the I/O statistics data to display on the graph. Select at least two
check boxes.
describes I/O statistics data.
NOTE:
To display Average Transfer Rate, Average Response, or Pair Synchronized, do not select
any other statistics at the same time. The graph can display only one type of data at a time: I/O
count, rate, response time, or percent.
6.
Click Set. A graph showing selected I/O statistics data for the selected LUs appears.
7.
Complete the following tasks if needed:
• To enlarge the displayed graph, right-click the graph, and click Large Size.
• To return the graph to normal size, right-click the graph, and click Normal Size.
• To stop displaying the usage monitor graph, right-click the graph, and click Close.