HP StorageWorks XP10000 Disk Array - Manual (Page 139)

Figure 99 Change Community Pop-Up Menu
Figure 100 Change Community Pane
Adding Community IP Addresses
To add a community IP address:
1. Log on to open the XP Remote Web Console main pane and then click Install ( ). Click the SNMP
IP Security tab to display the SNMP IP Security pane ( Figure 93 ).
2. Select and right-click the desired community to display the Add Community popup menu (see
Figure 101 ).
3. Select the Add IP Address command. The Add IP Address pane is displayed (see Figure 102 ).
4. In the IP Address box, enter a new IP address or select the existing IP address.
5. Click OK. The new IP address is displayed in the Community & Trap box, but the change is not yet
implemented to the array.
6. If you want to apply the changes to the array, click Apply. Click OK. If you want to cancel the
changes, click Cancel.
HP StorageWorks 139